The generator cannot turn on or start:
1. First check whether the engine oil and gasoline (diesel) are newly added. Otherwise, they have been added more than three months ago. and gasoline (diesel) must be drained and replaced again. (Since engine oil and gasoline (diesel) are only valid for three months, oil and gasoline (diesel) that have been used for more than three months have lost their viscosity and have no effect.
2. engine oil and gasoline used in generators? Refuel If not filled, the generator will not ignite or start <. /p>
3. If it's not on fire, remove the spark plug and see if the generator is on fire, you'll be fine
Causes and solutions for diesel generators not starting:
1. Check the oil circuit problem
>The engine oil circuit is not fluide. You have to check. if the engine oil circuit is fluid. If you hear a grinding noise coming from the fuel injector, prove that there is no problem with the oil system
2. Check cylinder compression. If the steering wheel can still turn after releasing the pressure reducing device, there is a cylinder compression problem and the cylinder needs to be replaced. The piston and piston ring are damaged. The lubricating oil should be replaced in time. does not promote smooth engine starting. Check if there is air in the oil pump, the diesel engine will not start
3.
When the temperature is too low in winter, the diesel locomotive cannot start in the morning. It is difficult to turn on the car in the morning. At this time you need to be careful. first position, there will be a diesel preheating and preheating light on the dashboard Wait for about 10 seconds This is thea glow plug indicating insufficient heat. Then press the clutch, the accelerator, turn the key all the way and. Refuel at the same time. Observe whether the oiling is proceeding correctly. Usually the oiling does not proceed properly at this time.
Diesel engine maintenance precautions
1. sufficient and clean.
Be sure to refuel the air filter in place; valve clearance is adjusted in place; the valve seal is ground in place
2. Fuel injection atomization
Make sure the fuel is adjusted in place; fuel supply time is set in place; oil pressure is normal
Make sure the filter is clean and the crankshaft oil chamber is clean