The motorcycle cannot start because there is no high voltage power supply. The cause of the failure lies in the various components of the ignition system, as well as the wiring, plugs, switches and other parts between these ignition systems. Check these components and simply wait for the wiring, find out the specific reason why there is no high voltage, then repair or replace the problem parts as necessary.
Motorcycles do not have high voltage electricity. This is simply a problem with the ignition system components and wiring, and has nothing to do with other parts. When this happens, separately check the spark plug, high voltage assembly, igniter, magneto stator coil, ignition switch door lock, kill switch (if equipped) ), etc. separately to see if there are any problems and if the circuits between these parts are broken or endamaged. Short circuit faults, loose wiring plugs, poor contacts and lack of high voltage power are some of these faults. If it is an electronic fuel injection motorcycle, check for problems with the ECU and sensors related to the ignition system.
To check the circuit failure of the motorcycle ignition system, you can use a multimeter to detect it. In addition to using a multimeter and special testing instruments to check the ignition system components, it is best to do this. replace the test with the same new parts. This is more intuitive and precise and makes it easier to find the specific cause of the fault. After finding the specific cause of the fault, you can repair or replace the problematic parts and circuits, as appropriate. Generally, damage to the igniter, high voltage box and magneto coil cannot be repaired and cannotonly be replaced by new ones. Other parts may be repaired or replaced depending on the situation.