The method to deal with the ignition pin not discharging is as follows:
1. When we encounter a spark pin that won't discharge, we must first find the problem. It may be that the battery is low or the battery contact is bad, so we need to replace the battery. Generally speaking, you choose a large battery, which only requires one section. You can replace it directly after finding it at the bottom, and install it according to the positive and negative poles. Make sure the contact is good and try relighting the fire to see if it succeeds.
2. If there is still no effect after replacing the battery, the ignition switch button may be malfunctioning and malfunctioning. In this case, you can contact the brand's after-sales service to replace the switch button with a new one.
Advice forur solve the problem
If there is still no solution after replacing the switch button, the most basic problem is that there is a problem with the ignition. Because it has been used for a long time, the ignition needle is covered with oil, and if left for too long, ignition will fail. The position can also be shifted, because there are certain requirements for the distance between the ignition needle and the fire cap, which is generally around 4-6mm. It must be aligned with the fire hole to be effective.
The oil on the ignition needle should be wiped off and the position adjusted. Line up the fire hole according to its location and see if it works. It's better if it works. If it doesn't, it doesn't matter. You can call the maintenance phone number and professionals will repair it.
Double needle ignitionis good. Generally, single pin ignition is electric ignition by ignition needle discharge, and double pin ignition is electric discharge ignition between two needles. The single ignition needle is usually fixed on the side plate of the combustion chamber and has an ignition distance of 4-6mm from the fire row. However, if the distance between the two is greater than 6mm due to assembly problems or other reasons, it will occur. cannot catch fire. The double ignition pins are connected together and fixed on the side plate of the combustion chamber, which prevents assembly errors and the ignition distance is always 4-6mm. Double ignition needles are therefore better.