You must have removed the dispenser, right? If you are using a flat-blade screwdriver to turn the starter, remove the distributor when the flywheel reads 0.1.2.3 or a larger point, and point it toward cylinder one or four at an angle of about 45 degrees, if you don't. If you're not sure which is single-cylinder and which is four-cylinder, open the cabin side seat and look at the cylinder line. The one on the steering wheel side is the single cylinder and the one on the rear. It's the four cylinder. It should be okay, I hope. If you still can't do it, just find a bread repairman on the street.
How to disassemble the Chery qq6 generator
It's been there for a long time, hasn't it? At least six months. If this is the case, the gasoline in the carburetor has evaporated over time and the colloidal substance in the oil has blocked the measuring hole in the carburetor, so it cannot be removed. Checkalso the amount of gasoline in the fuel tank. Loosen the oil drain screw under the carburetor to see if there is any oil. Remove the high pressure cap from the spark plug and check for a spark (unscrew the high pressure cap). cap to expose the wire core inside). The metal parts close to the machine are about 5 mm away and pull the motor). If there is a spark, there is no problem with the ignition system. Then unscrew the spark plug and check if. the spark plug is good. You can put it on the high voltage cap and lean against the metal parts of the machine and pull the engine to see if the spark plug is OK. If there is a fire, there will be. there will be no problem. Focus on checking the oil line and carburetor. Hope this helps.
How to disassemble the Chery qq6 generator as follows
First unplug thee negative pole of the battery cable, then remove the motor shield, then remove the live wire and signal wire. on the generator, then remove the three screws that secure the generator, then remove the belt from the generator to disassemble it. Why are you dismantling the generator?