Install and use according to certain specifications, pay attention to safety, the usage steps are as follows:
1 To avoid electric shock accidents, please connect the earth wire. first when using this machine.
2. Please use unleaded gasoline 90# or higher. When refueling, first remove the fuel tank cap (turn counterclockwise), then add fuel and observe the fuel level gauge on the fuel tank at all times. Do not remove the fuel filter from the filler port when refueling. (When refueling, you should stop the generator and pay close attention to the surrounding fireworks) Do not add oil to the top of the ultra-filter.
3. Add the specified capacity of four-stroke generator oil to the crankcase. Remove the oil dipstick to check the capacityoil quantity. The oil level should be between the dipstick grids and the best condition is above the middle.
4. When filling the engine oil, remove the black oil filler cap by turning it counterclockwise and inject the engine oil. Check again after a minute to see if the oil level is appropriate. There is an oil pressure sensor in the engine. If there is not enough oil, the generator cannot start normally. If there is too much oil, the generator cannot operate properly. Please drain the excess oil through the oil drain fitting.
5. After the generator has been used for 10 to 15 hours during the break-in period, it should be replaced with new engine oil. In future normal use, depending on the use environment and strength requirements, replace new engine oil once after 30-50 hoursof use.
6. If the total usage time of the generator does not exceed 30 hours in a six-month period, please replace the engine oil with new one when using the generator again. Always check whether gasoline and engine oil are filled to a safe level before starting the generator.
For reference only and without authoritative data.