Ford Transit New Era V348 generator belt, the grooved side is laid on the pulley, and the smooth side is laid on the tensioner pulley, so that it passes through the crankshaft, water pump and motor pulleys. power transmission is carried out. The specific installation steps are as follows:
1. Use the tool to loosen the tension screw from the tension wheel.
2. Remove the loose belt.
3. Remove the new belt and install it according to the pulley.
4. Check if the belt is wound correctly.
5. Tighten the tensioner tension screw to complete the operation.
Detailed information:
The function of the timing belt is when the engine turns, the stroke of the piston (up and down movement), the opening and closing of the valve (time), the sequence of ignition (time), under the "timing" connection, always keep the operation "synchronized".
The timing belt is a rubber component. As the running time of the engine increases, the timing belt and its accessories, such as timing belt tensioner, timing belt tensioner and water pump, etc. become more difficult. or age.
Main stepsto increase the pressure from zero:
1. The boiler is turned on, the turbine evacuates and the generator and the excitation system are put on standby.
2. Run the turbine, check that the generator protection is put into service and that the excitation cabinet is put into service.
3. Set the turbine speed to 3000 rpm and close the excitation switch.
4. Adjust the resistance of the magnetic field and the generator begins to increase the voltage from zero.
5. Do not increase the voltage too quickly from zero and stop at 50% of the rated voltage.
6. The generator stator voltage increases to the rated voltage. The boost ends at zero.
Notes: The generator excitation system is different and the operation steps are different. You can also reduce the main voltage to zero to increase the voltage.