The motorcycle ignition is equipped with 5 pins, which are input, output, off, trigger and ground. The specific steps to connect these pins are as follows:
1, The picture shows the trigger pin.
2. Connect the generator to trigger the blue and white wires.
3. The picture shows the ground wire.
4. The green line connecting the car body.
5. The picture shows the extinguishing pin.
6. The blue and red lines of the key ring.
7. The picture shows the power pin.
8. Connect the voltage input terminal of the black and yellow wire of the ignition coil.
9. The picture shows the power input pin.
10. Where do the black and red wires connecting the generator come from.
After detecting a power failure, turn the ATS to position 0 and use the contacts to start the diesel generator. Once the generator output voltage diesel is normal, put the ATS in position 0. on the generator side and start the switching completed; It is detected that the grid power is normal, switch the ATS to the grid power and use the contacts to stop the diesel engine.