1. First check if the engine oil and gasoline have been added recently. Otherwise, they have been added for more than three months and the oil and gasoline need to be drained and replaced. Engine oil and gasoline are only valid for three months. Oil and gasoline used for more than three months have lost their viscosity and are useless.
2. Check if the engine oil and gasoline in the generator are filled. Otherwise, the generator will not turn on or start.
3. If the above conditions are met, check whether the spark plug ignites. Otherwise, remove the spark plug and put gasoline on it before reinstalling it to see if the generator fires. , it would be good if it started with the ignition.
Detailed information
Before each use of a gasoline generator, the following checks should be carried out to ensure safe and normal use of the generator: p>
1. If the generator is not used for a long time (more than a month), the starter battery will lose power due to self-discharge. Please use an external charger to charge the battery.
2. Check if there is enough gasoline in the fuel tank.
3. Check the oil switch and oil pipeline for oil leaks.
4. Check whether the battery starting voltage is higher than 12V and observe whether the battery appearance is damaged or leaking.
5. Observe the quality of the engine oil to determine if it needs to be replaced.
6. Check if the engine oil level is between the oil dipstick grids.
Baidu Encyclopedia - Gasoline generator
5KW low speed electric vehicle range extender
The range extender autonomy can be started by hand, but it does not light Not on fire?
New machine:
1. Disconnect the oil pipe from the carburetor to see if the oil is flowing properly and increase the idle speed slightly.
2. If there is no problem with the oil, check to see if the spark plug is burning.
3. If there is oil and fire but still no ignition, check reverse and forward rotation. (Press in the direction of the handle to rotate forward)
4. Then check if the air door is closed normally.
5.? Check if the measured voltage is too high. The 60 volt protection voltage is 68 volts, and the 72 volt protection voltage is 80 volts.
6. The carburetor should be cleaned after leaving it too long. Before use, add 5 ml of engine oil and read the instructions carefully.
Old machine:
1. Unscrew the spark plug and determine if there is a fire and carbon deposits.
2. Wipe the spark plug and install it. Start the rallynge. If it still doesn't catch fire, remove the spark plug and see if there is any oil on the spark plug. Otherwise, clean it. the carburetor or replace it. After cleaning, blow with an air gun.
3. Open the air filter cover and check whether the air door switch is normal.
4. Return to factory for repair.
Since the cruising range of low-speed four-wheel electric vehicles is still relatively limited and cannot fully meet the daily travel needs of the public, if you want to increase its cruising range , you can install a range extender toThis will increase its cruising range, expand its range of activities, meet the daily travel needs of the public, and enable traveling freely, without the difficulty of running out of energy halfway.