1. Reasons why the gasoline generator cannot turn on
1. If the engine oil and gasoline of the generator are filled Otherwise, the generator will not be able to ignite and start.
2. If the engine has not been started for a long time, engine oil will flow back into the oil pan. When the engine first starts, there is no engine oil lubrication and the cylinder pressure cannot. At this point, too much gasoline (cold oil) will not be used. If it burns and smothers the candle (the candle is wet), remove the candle, wipe it clean and burn it with a lighter. for a moment and put it back in place, or simply replace it with a new spark plug. (These are usually the reasons. If you remember, it can be used on many cars.)
3 If it is not commonly used, it will usually be difficult to start when it is used. The carburetor oil level will drop and the oil level at the iThe inside of the carburetor will drop. At this time, too much gasoline (cold oil) will not burn, block the oil hole, or directly replace it. a new spark plug. This is because it is not commonly used, the carburetor oil level drops and the cylinder pressure reaches. Otherwise, use a lighter to burn it for a while and put it back.
Gasoline generator oil leakage
The phenomenon of diesel generator engine oil leakage, especially in some domestic brands of diesel generator sets, Oil leaks occur often, so we how to analyze the location of the oil leak and then solve this problem? Diesel generator manufacturers offer you the following solutions:
1. The quality of purchased or homemade paper pads does not meet requirements, such as insufficient thickness, or storage Improper installation,wrinkles and deformations, careless cleaning during assembly, as well as dust and impurities are all causes of oil leaks.
2. The oil pressure is too high, which also causes oil leakage on the gasket surface.
3. The quality of the gasket surface itself is mainly determined by the precision of the processing equipment itself and the storage and transportation conditions. If the equipment has high precision, if the flatness and roughness of the surface of the static seal can meet the design requirements of the drawing, and if precautions are taken to avoid collision during storage and transportation, it will not be difficult to achieve complete sealing of the gasket surface. However, due to the low level of precision and manufacturing of some manufacturers' equipment, the storage and transportation conditions as well as the levelThe management cannot completely guarantee that there will be no bumps or scratches.
There is a black pipe coming out of the air filter of the Zongshen gasoline generator, but when the hot air comes out, the oil is exposed. What is the reason ?
Hello, the oil in this air filter housing is completely sprayed from the engine end which you think can be easily removed through the rubber tube and flows into the housing of air filter. Have you changed the generator oil recently? The second is that the part with the hole (this part is called the cylinder head cover) is broken and needs to be replaced. The other is that the engine ages, where the exhaust originally comes out, but once the engine ages, the engine ages. The cylinder is damaged due to poor sealing of the piston rings. The gas inside flows into the crankcase, increasing the amount of exhaust gas or causing theoil spraying from the engine. By the way, this phenomenon is called oil spraying, and it is also. a common phenomenon in domestic horizontal motors after aging! I don't know if you can understand what I'm explaining like that!
First check whether the viscosity (label) of the engine oil is appropriate. If the label is too thin, there will be serious problems. The amount of engine oil that overflows depends on your description. This type of general machinery uses a wet air filter, which uses the oil foam during crankcase ventilation to moisten the filter sponge, so that the sponge contains a certain amount of oil. moisture in engine oil. To achieve the purpose of adhering fine dust, a small amount of oil will be sprayed from this port during normal operation, but it will not flow from the filter housing to the ground. Excess oil will be sucked into the ground. cylinder tothrough the suction stroke to participate in combustion.