There are many reasons why the gas stove cannot ignite via ventilation. 1. The battery powering the gas range may be discharged. 2. The ignition needle of the gas stove may not be able to ignite. For example, the ignition needle is dirty, rusty, etc. 3. The high voltage line of the gas stove may be broken. 4. This may be a failure of the gas stove microcircuit. Suggested Solutions: 1. Firstly, you should replace the new battery in time so that the battery can maintain enough power to power the gas stove. If the gas stove still cannot light normally after replacing the new battery, you need it. to check the gas stove battery. Check for rust where the battery sits in the slot. If rust is detected, it will result inpoor contact with the battery. These rust spots need to be cleaned. 2. After recharging the battery, if the gas stove still cannot ignite, you should check whether the gas stove ignition needle is covered with dirt or covered with rust stains and others tasks. If so, these rust stains and other items are necessary. to remove. 3. Regardless of which brand of gas stove you purchase, high voltage wires may age due to long-term use, resulting in failure to ignite the fire. At this point you should use a multimeter to check if the fire is on. two high voltage wires are live. If they are old and there is no power, you need to remove these two wires and replace them again. 4. If it is a circuit fault, you must ask a repairman to carry out the repairs.
The ignition starter is broken: lThe ignition starter of the gas stove is broken and the liquefied natural gas cannot be completely burned during use. In this case, an open leak may also occur, which is not only subject. poisoning, but also prone to explosion, you should call the customer maintenance personnel in time and replace the ignition cap immediately. Stove overpressure protection: Many gas stoves have an overpressure protection function. When the pressure exceeds the rated range, they will not start. At this point you should consider replacing the pressure reducer. It is possible that the position of the ignition needle has deviated. In normal use, there are requirements for the distance between the ignition needle and the fire cover. If the position deviates a lot, the gas stove may not ignite. You need to find professional maintenance personnelto check and adjust. There are many reasons why a gas stove may stall. It is recommended to first check if there is a problem with the gas valve and the cooker battery. Gas Stove Maintenance: Gas stoves need to be cleaned regularly. Oil stains caused by a gas stove after being used for a period of time not only endanger sanitation, but can easily cause the gas stove to be blocked, so gas stoves should be cleaned regularly. For the maintenance and inspection of gas stoves, hire professional technicians to regularly check the tightness of the stove and gas system with foam glue. Cleaning stoves, cleaning stove tiles. Use discarded candle holders to make the candle surface smooth and clean. Even if there are stainsoil on it, just wipe it off with regular detergent and water. Slowly wipe the joints of each tile, first in the direction of application. the joints, then apply it again horizontally. Try to increase the thickness of the candle in proportion to the thickness of the tile. The cleaning method is to mix three spoons of rice vinegar with 200ml of warm water, then use a sponge and eco-friendly loofah pulp to soak in this "hot vinegar water" to clean the stainless steel cooker and make it as shiny as new.