The correct answer is that the gasoline engine can be used. The stator and rotor are just the generator part and the power part is completely separate. Have you ever seen one that sells gasoline engine power? There is also the water pump supplied with the petrol engine. Farmers buy a gasoline engine and add it to the thresher for threshing. And do you understand this jiachenchong? The spark plug ignition coil of a gasoline generator is installed on the gasoline engine. There is a permanent magnet on the steering wheel. Rotation of the steering wheel and induction of the ignition coil generate current to the spark plug and the gasoline engine starts. Every time the steering wheel turns, the spark plug lights up. It has nothing to do with the battery. In addition, current gasoline generators under 5 kW are mainly started manually and do not have a battery.
What is wrong with the alternator note not working?
Car AlternatorTo disassemble and assemble, you must first remove the belt from the alternator and then remove it. The generator mounting screws can complete the removal of the generator. Below we have compiled some relevant content to share with you. If you are interested, don't miss it and take a look! The specific steps are as follows:
1. Remove the generator drive belt.
2. Loosen the generator mounting screws.
3. There's another one below.
4. Remove the generator by shaking it.
5. Use mounting screws to secure the new generator.
6. After fixing, install the drive belt and you're done.
Notes
Alternators are widely used in automobiles. You should pay attention to the following points when using them:
1 Clean the appliance frequentlythis from the generator. to remove dirt and debris, keep clean and well ventilated.
2. Frequently check the tightening conditions of the generator-related fasteners and tighten the screws in time.
3. The tension of the drive belt must be appropriate. If it is too loose, it will slip easily and result in insufficient power production; if it is too tight, it will easily damage the belt and generator bearings.
4. When installing the battery, be careful not to install it incorrectly. Usually, install the positive wire first and not the ground wire, otherwise the diode will burn out easily.
5. When using an integrated circuit regulator, the ignition switch should be turned off immediately when the engine is not running.
6. It is never allowed to use the “scratching” method to test whether electricity should be produced.
7. When the generator does notfails to generate electricity, it must be eliminated in time, otherwise it will cause a more serious breakdown.
Reference for the above content: Baidu Encyclopedia-Car Generator
There are many reasons why the generator cannot fire.
The main reasons why the generator will not fire are:
1. The mixing problem. After removing the spark plug, let the machine run more often. It is best to start it with electricity or by hand. Okay, pull it about 10 times. While pulling, stick your finger into the spark plug to check for kickback. After pulling it a few times, feel the finger you have. plugged in. There is a smell of gasoline. If you can start it before, then after checking like this, if your finger smells gasoline, it will probably be able to start. Of course, this must be on the assumption that the spark plug est. lit, and you need to adjust the throttle after emptying the match.
2. The oil alarm isolator problem is nothing as long as the current can ignite. Your generator will not start if there is no oil or not enough oil. Check if there is enough oil. You said your generator hasn't been used in two years. It's possible that the engine oil protection device has failed because it hasn't been used for too long, but that doesn't matter. Check if the start failure is caused by the oil alarm. After making sure there is sufficient engine oil, try the starting method to see if the electrical ignition is turned on. If so, everything will be fine.
3. There is a problem with the oil circuit. Check the pressure ratio. It can also be caused by a lack of oil and an insufficient pressure ratio.
4. The problem of useUncommon is that the carburetor oil level drops, corrosion occurs inside and the oil hole is blocked. Engine oil flowed back into the oil pan after it was not. started for a long time. When it is started for the first time, when there is no engine oil lubrication, the cylinder pressure cannot be reached at that time, too much gasoline (cold oil) n is not burned and the spark plug is snuffed out. the candle is wet).