After a hard day, I wanted to take a hot shower after getting off work, but the gas water heater I was using suddenly stopped turning on. Who would be very distressed when encountering such a problem?
There are many reasons why a gas water heater may not catch fire. The reasons for failure of different brands of gas water heaters are approximately the same. When you encounter this situation, be careful not to repeat ignition to avoid explosion inside the water. heating.
1. First check if there is an error code displayed on the gas water heater's display screen. If an error code is displayed on the gas water heater, check the gas water heater manual. to determine the meaning of the error code. Find the cause based on the meaning of the prompt. If you are asked to report a repair, promptly call the after-sales hotline to report a repair.paration.
2. If the gas water heater you purchased does not have a display screen, it is more appropriate to directly call the after-sales telephone number for consultation and conduct a step-by-step inquiry according to the prompts after -sale.
3. Perform a simple inspection of the water circuit, electrical circuit and gas circuit. A water outage will cause insufficient water supply pressure to the water heater and prevent the water heater from igniting. Determine if there is a gas outage, you can use a gas stove at home to light, such as a gas stove. If the cooker can be used normally, it can be ruled out that the cause is not the forced ignition power supply; -The gas discharge water heater is powered by the city. You can use a test pen to check if the electrical connection socket is damaged. The electrical power supply for ignition of the gas water heaterconduit consists of two sections no. 1 installed under the water heater. The battery provides the energy necessary for ignition. If the battery is low, replace the battery and the problem will be resolved.
4. Gas Water Heater Duct Inspection: The exhaust duct installed in the gas water heater must use stainless steel conduit to lead outside. I encountered a relatively typical case when repairing water heaters. The gas water heater in the user's home failed to ignite. I verified that the circuit board, water path and gas path of the water heater in the user's house were normal. The reason is that the user used aluminum foil to extend the flue. The air inlet has no wind protection measures, causing birds to enter the flue and build nests, making the gas water heater unable to exhaust smokeand therefore incapable of igniting. You can make a judgment call by checking the flue air inlet to see if there is a blockage.
If the problem cannot be eliminated through the above inspections, be sure to contact the regular after-sales personnel of the gas water heater for door-to-door repairs. Do not allow unqualified personnel to carry out repairs to avoid. gas leak after repair, which may present a danger.
Use gas safely and warmly for you and me. Follow and subscribe to the conference room public account to get more gas knowledge.
The principle of gas power generation is to use gas to drive a motor connected to a generator to produce electricity
The motor and generator are coaxial. connected and placed in the complete machine On the chassis, silencer and regulatorgear are connected to the engine, the gas source is connected to the gas channel in the engine, the recoil starter with a pull rope is connected to the engine, and the voltage regulator is connected to the output end of the generator . The fuel gas placed in the gas source is natural gas, liquefied petroleum gas or biogas. Compared with gasoline generators and diesel generators, the use of gas generators reduces environmental pollution and is an environmentally friendly and energy-saving generator. And the structure is simple, Its use is safe and reliable, and the output voltage and frequency are stable.