Check the electric start switch for damage.
If there is no power after turning on the key and electrical appliances and switches do not respond, check if the battery is discharged, if the wire of the battery is in poor contact, if the battery fuse is blown and if the electric door lock is damaged, if there is an open circuit or a short circuit in the vehicle circuit. If the horn, turn signal, etc. are powered after turning on the key, but the electric starter does not respond, check if the electric starter is damaged, if there is a problem with the brake switch (the pedal must be used when electric starting of a female motorcycle), the starting relay and the starter Check if the engine is defective, if the electric starting circuit is open, etc.
Loading the motorcycle requires the engine to be started to eDrive the generator to charge the battery. If it cannot be started, it will not automatically load. You can simply find a downhill slope and let the bike slide. When the speed increases, add a little oil to light it several times. If it doesn't come down, ask someone to push it for you. You can also open the motorcycle seat, find the battery, and then search for it again. For a motorcycle or electric car, find a section of wire and connect the two batteries for power transmission. Pay attention to positive and negative levels. is positive and black is negative. 3. Go to the repair shop to borrow a special charger to charge the battery or take it out from the battery charging store.
Spark Plugs for Generators
The specific steps for replacing spark plugs in portable generators are as followss:
Tools required: screwdriver, socket.
1. When disconnecting the high voltage wire connector, be gentle. Do not shake the spark plug insulator forcefully during operation, as this may easily damage the sealing performance of the spark plug.
2. The motor can be disassembled after cooling. After loosening the spark plug, use a thin hose to blow out the dirt around the spark plug to prevent dirt from falling into the combustion chamber after unscrewing the plug.
3. The area around the screws, spark plug electrodes and gaskets must be kept clean, dry and free of oil, otherwise it will cause electrical leaks, air leaks, weakening of sparks and d other defects.
4. When installing, use a sleeve to align the spark plug with the screw hole, and gently screw it in by hand. After the drinkir tightened to approximately half the total length of the thread, tighten. the lever with additional force. If the hand is not smooth when twisting, go out and check if the threads are aligned or if there are any impurities trapped in the threads. Do not tighten blindly to avoid damaging the screw holes and damaging the cylinder head.
5. Tighten to the required torque. If it is too loose, it will cause air leakage. If it is too tight, the gasket will lose its elasticity, causing air to leak.
The correct answer is that the gasoline engine can be used. The stator and rotor are just the generator part and the power part is completely separate. Have you ever seen one that sells gasoline engine power? There is also the water pump supplied with the petrol engine. Farmers buy a gasoline engine and add it to the thresher for threshing. And do you understand this jiachenchong? The coil hasThe spark plug illumination of a gasoline generator is installed on the gasoline engine. There is a permanent magnet on the steering wheel. Rotation of the steering wheel and induction of the ignition coil generate current to the spark plug and the gasoline engine starts. Every time the steering wheel turns, the spark plug lights up. This has nothing to do with the battery, much less with current gasoline generatorsThose under 5 kW are essentially started manually and have no batteries.