Hello, there are several reasons for this. Firstly, there is no oil, secondly, the oil circuit is blocked, thirdly, the body temperature is too high, and fourthly, the load is too great. These situations will cause the gasoline generator to automatically stall during operation.
It is recommended to replace the spark plug and carburetor. If it is certain that the spark plug is not the fault, it is recommended that the oil supply line is not slick and cleaned or replaced.
1. Carbon deposition in the engine: Carbon deposition will cause insufficient combustion of gasoline, causing the engine to stall. Carbon deposits in the engine have a significant impact on the car. The first is to reduce the engine power, which means that the power output is uneven and gradually attenuates. The second is to increase carb consumptionurant and increase the economic burden. Third, it is difficult to start the car when cold, that is, it is difficult to ignite and it is not easy to start the car. Finally, heavy carbon deposits in the combustion chamber can cause knocking in the cylinders and make noise when starting. acceleration at low speed, damaging the piston and crankshaft, causing high engine temperature and serious consequences for the safety of the car. In addition, if the emissions exceed the standard, it will not only fail to pass the annual inspection, but also directly increase the damage to the environment.
2. Under-load operation of the gearbox: Under-load operation of the gearbox will destroy the quality and friction characteristics of the gearbox oil, increase friction and wear, and at the same time cause noise (impuresummer or dirt). dirt) will also be generated inside the gearbox (such as the valve body), causing the gearbox to deform, shift, impact, slip, stall, abnormal noise , delay, high temperature and oil leakage. If the problem is not resolved in time, the gearbox will be scrapped.
Reasons why Honda Spiral suddenly won't start:
1. Is the steering wheel locked? The solution is simple. As long as you turn the steering wheel firmly and turn the key at the same time, you can usually quickly unlock the steering wheel and turn on the ignition instantly.
2. Did you not put the gear back into P when parking? Think about it, if the ignition can be done in D or R, the movement of the vehicle at the time of ignition will undoubtedly be a huge safety risk. . Therefore, for vehicleswith automatic transmission (AT, CVT, AMT), manufacturers will predefine this mode and indicate several times in the instructions: Make sure the gear is in position P when switching on.
3. Check if the battery has power. Failure to start the light may be due to loss of power or expiry of battery life for reasons such as leaving the headlights off for a long period of time. Generally, the battery should be replaced in time according to the service manual.
4. Check if there is oil. If the oil gauge indicates that it is below the red line, this will naturally not start a fire. Also pay attention to the quality of the oil. A car owner once took his car apart and discovered that there was water and mud in the fuel tank. With such oil, it would be impossible for the car to break down.
5. Without adding antifreeze, some car owners add water or poor quality antifreeze to the car. As a result, when the winter is extremely cold, the entire waterway is frozen, the engine is frozen and cracked. , and the car's water pump cannot work, unable to ignite and damaging other engine parts.