Breathtaking combustion gas compression. The principle of generator power generation is that the wires cut off magnetic fields to generate electrical energy if they are not used for a long time or burn out during use, the magnetic field inside the generator will be completely consumed. magnetic field, electricity cannot be generated. I The best method is to suddenly accelerate and decelerate the accelerator several times. Generally speaking, power will come out slowly.
Generator Maintenance
Choose the Right Engine Oil When choosing engine oil, you need to know the ambient temperature of the vehicle and then the use accordingly. the vehicle manual. Check the quality and viscosity of the oil when purchasing engine oil. Remember to pack it when changing the oil. Each time the vehicleshort a certain number of kilometers, you need to replace the engine oil and the third filter. routine maintenance. Usually there will be some left after an oil change. Don't forget to add the remaining oil. Pack it up and remove it for later use. Do not mix engine oils.
Sometimes it turns out that the car's engine oil level is insufficient and it is necessary to add engine oil. At this point, be careful not to add different brands or types of engine oil to avoid oil leaking. deteriorate. Pay attention to the degree of wear of the bearings. If lubrication is found, if it is not sufficient, you can drop a few drops of engine oil from the mouth of the oil cup. Be careful not to enter the rectifier, otherwise it will affect the power transmission effect.
In addition to spark plugs, the highest failure rateis the combined coil that generates electricity in the high voltage coil motor. Inspection Steps: 1. Remove the spark plug and cover it with a high voltage cap. Touch the spark plug to the metal shell of the engine and turn on the machine to check the performance of the spark plug. 2. Check the high temperature! Voltage coil and motor trigger coil. First use a multimeter to measure the impedance, and then measure the voltage of the high voltage coil on the machine. The output wire is red and black, and the trigger coil output wire is blue. and white. There is no multimeter that can detect the short circuit method. Normally there will be sparks caused by the short circuit! 3. Check the output voltage of the yellow and black igniter wires. You can also use the instantaneous short circuit method. Normally there is a spark caused by ashort circuit. Check the igniter, disconnect the black and white wires, and check the spark plug for spark. The black and white wires are the wires from the dead light switch to the power door lock. When the electric door lock leaks, the igniter does not come out. high tension. 4. The input wire of the high voltage box is the yellow and black wire. If there is voltage in the yellow and black wires, remove the high voltage cap and check for sparking in the high voltage wire. the normal distance between the high voltage wire and the motor shell is 0.5-0.2cm. Sparks appear when starting the machine.