30 cm. For photovoltaic supports in category 14 typhoon areas, cement piles with a diameter greater than 30 cm are selected to ensure their stability and safety. When designing and constructing cement piles, relevant building codes and safety standards must be followed to ensure their strength and stability. At the same time, photovoltaic racks also need to be fixed and protected to avoid accidents in extreme weather conditions such as typhoons.
How much does it cost to drive cement photovoltaic piles per meter? There are many solar photovoltaic piles
There are many forms of foundations, including:
1. Cast-in-place bored pile foundation
2. Cast-in-place foundation for large-scale excavation
3. Weighted concrete block foundation
4. . Pot-type precast concrete foundationhot
< p>5. Spiral pile foundationDifferent topographies and geological conditions require different forms of foundation.
In general, cast-in-place piles and screw piles are cheaper, but their application environments are limited.
How many square meters is the factory building for producing photovoltaic cement piles
Tianjin photovoltaic bracket factory and a complete set of accessories
41*41* 2.0*2.3*2.5 (in stock)
41*52*2.0*2.3*2.5 (in stock)
41*62*2.0*2.3*2.5 (in stock)< /p>
In stock: photovoltaic brackets, accessory bases, triangular connection, direct bracket connection, nuts and plastic thumb screws, medium pressure, side pressure, hose clamps, roof hooks, U-bolts, etc. Distributed supplement, fishing and photovoltaic, agricultural and photovoltaic supplement, photovoltaic on roof, photovoltaic greenhouse, s systemPhotovoltaic support based on cement on the ground.
More than 4,000 square meters. The factory area required for a photovoltaic module production line varies depending on factors such as production line scale, process flow and equipment selection, but it normally requires a factory building of more than 4,000 square meters, including production workshops and storage. areas, office areas and support facilities.