Installation of anti-static floor mats
1. The floor should be clean and tidy
Not all places can lay anti-static floor mats, so before laying the floor mats. , everyone must first The intended use is to tidy up the paved floor. The ground should be flat without any obvious irregularities; the ground should be strong enough without any areas of sand or shelling, at the same time the ground should be dry. It is not good to lay floor mats on a damp floor; After checking all these factors, clean the floor with gasoline or xylene to ensure that there are no impurities on the floor.
2. Preparation of installation tools
To install anti-static floor mats, steel bars or aluminum bars are required. When laying, these steel or aluminum bars should be laid frequently, and a section of them should be grounded, note that the length and width ofmust be determined based on the actual situation.
3. Formally lay the floor mat
Then lay the conductive mesh and apply a little conductive glue to the floor. After the glue dries, glue the bottom surface of the floor mat. ground. combine together. To make the floor mat stick firmly to the floor, you can roll it 5 times with a heavy roller until the surface of the floor mat is flat and flat. Note that when laying the floor mat, the temperature should not be lower than 25 degrees Celsius and ventilation should be maintained so that the conductive glue can dry quickly.