If the Pacific Automotive Network battery is swollen, it can no longer be used and recharging will be unsafe. If the battery swells, it will continue to generate high temperatures. If it encounters flammable materials or wires melt, it is easy to cause a fire. The “vaporized lead” produced by the charge can easily cause lead poisoning in the human body.
If the battery is bulged, it can no longer be used and recharging will be dangerous. If the battery swells, it will continue to generate high temperatures. If it encounters flammable materials or wires melt, it is easy to cause a fire. The “vaporized lead” produced by the charge can easily cause lead poisoning in the human body.
This is due to overload. The charger does not jump once the battery is full and continues to charge. If the battery is fully charged, the cBattery storage capacity will be significantly reduced. used, it will explode during the charging process. The danger is that the battery will become saturated within 7 to 8 hours of being depleted. It is recommended to unplug the charger in time after charging is completed.
Detailed information
1. First adjust the height of the saddle and handlebars so that they are in the safest and most comfortable position, especially the saddle height, which is best when riding. stopping during the process, both feet should be on the ground at the same time.
2. Test whether the braking device is effective and reliable, and test whether the power supply is cut off and the motor stops working after braking.
3. Check the battery level: When the device is on, check the battery level on the monitor, especially when it is in use after being left out fort a long time. In addition, it is also necessary to check whether driving safety elements such as electric horns and lights are effective!
4. Check rotating parts: front and rear wheels and pedals, cranks, sprockets, chains and flywheels to see if they are operating normally and if foreign objects are touching them.
(Photo/Text/Photo: Pacific Automotive Network Q&A)
The Pacific Automotive Network lithium iron phosphate battery is deflated and does not cannot be used. The pack is bulging. It will affect the use and cannot fit into mobile phone or digital camera. Additionally, the presence of gas between the battery plates will also affect the charge and discharge capacity of the battery. After deflation, it can be restored to its original size and used normally.
Choose the top of the lithium battery close to the bottom edgeof the sealing cover (be careful not to drill holes at the bottom of the battery, there is no space there), and avoid drilling holes for the electrodes. If the two electrodes are on both sides, you need to drill a hole in the middle. Now they are all aluminum shells. You can drill them by hand with a very fine instrument screwdriver. After drilling, be sure to go deep to avoid any danger. from touching the electrode plate.
If you're lucky, you'll hear the sound of gas escaping after being pierced. If you are unlucky, there will be no movement. Such a battery can no longer be used and must be replaced. . After pricking the eye, you can squeeze the bulging area with your hands appropriately to help the gas between the plates escape. Finally, seal it with tape to prevent air from entering. You can also use 705 silicone sealant.
You can see that there is a placeholder on the front of the lid. Note that if the battery is attached in the wrong position, there may be a partial short circuit, ignition and overheating. This position is not suitable for attracting attention. The battery itself is damaged (the battery mentioned here is the battery core itself). The inside of the battery core is a vacuum structure. Once the exterior is damaged, the battery is not far from being damaged. The connection phenomenon is booming.
Most people know that the battery is overcharged. The cause of overcharging is a bad charger. The cell voltage increases when it exceeds 4.25 V. The cell with good performance can be discharged for a while. the voltage drops, there will be no problem. In severe cases, he may not be able to recover. Even if it is flattened by an external force, it will be useless (and it ist usually difficult to flatten by external force. It's the case). due to the vacuum we just mentioned, or it is more accurate to say it is completely sealed.) means the battery is over discharged. The standard for over-discharging is that the cell voltage is below 2.7V. The cells will bulge once the voltage is below 2V. If it is below 1V, they will essentially be discharged. scum.
(Images/Text/Photos: Pacific Automotive Network Calling the Beast Q&A)