Hat crochet tutorial
I think the method for crocheting a hat is as follows:
1. Row 1: Start with 27 stitches and insert the 3rd stitch. Start by making a row of stitches of medium length without adding or subtracting hooks.
2. Row 2: 2 strands, turn over, choose the second half of the stitch and make a row of mid-length stitches without adding or subtracting the hook.
3. Rows 3 to 23: Same crochet method as row 2.
4. Then we fold the piece of fabric in half, sew one needle at a time, pick each half needle, hook and remove the needle to sew, break the thread and leave the end of the thread to close the top of the hat< /p>
5. Top of the hat: Insert the hook into the horizontal braid needle below, hook the thread, then insert the next horizontal braid needle in turn, hook the thread, and so on continuation, to finish the cratchet. Then we tighten the thread.
6. Finally, add pom poms to the top of the hat.
The problem of charging the motorcycle battery.
The method of knitting the furry hat is as follows:
1. Make 10 knotted stitches and make a row of long stitches without adding or subtracting hooks.
2. Turn over the second row, extend the spool, turn the hook to the right and under the spool, remove the first thread first, then remove both loops from the hook together. .
3. Hook a long needle over the second point, hook a set of outer hooks over the last 6 stitches and cross the top 3 straight stitches with 3 long rolled stitches over each of them. the last 2 stitches.
4. Crochet 2 long stitches in the third row, crochet 2 long stitches inside the 6 stitches.
5. The fourth line is the same as the second line.
6. ThereFifth line is the same as third line. Repeat the second to third row of loops to hang at a length suitable for your head size, break the thread and sew both ends.
7. Connect another wire and hook a long needle into each of the large and small spaces (a total of 64 needles were selected for demonstration).
8. Next, hook a long needle without adding or subtracting loops. Demonstrate hanging a total of 14 loops, including the selected loop, with a total height of approximately 30 cm.
9. In the last round, continuously hook the long needles 2 and 1, break the thread, turn the hat over, pick up the braiding needle on the top of the hat and tighten the thread, and attach a few more stitches to finish.
To charge the motorcycle battery, you can use a 12V7AH charger. Usually you can also use the 12V charger1 to charge the motorcycle battery if the ammeter reading is near 0. , Indicates the motorcycle battery is fully charged.
Motorcycles use a charger for slow charging, which typically takes 10 hours. Owners should be careful not to choose fast charging because charging for too long will damage the battery. In addition, the voltage during charging should not exceed 14.5 volts, and the current should not exceed one tenth of the battery capacity.
Detailed information:
Precautions for using the battery:
1. The battery will produce flammable gases when used and charged. It is strictly forbidden to place it near an open flame or cause high temperatures. You should also avoid shorting the positive and negative terminals and excessively loosening the positive and negative terminals.
2, The electrolyte contains strong acid, avoid splashing on skin, eyes and clothing. In case of contact, rinse immediately with plenty of water. If swallowed by mistake, immediately drink plenty of water or milk and send it to the hospital for treatment.
3. Users are recommended to check the fluid level every 1-3 months. If the liquid level is below the lowest residual level (LOWER LWVEL), add distilled water to the upper level line. It is best to recharge the battery after adding water. Maintenance-free battery. In addition to not adding water, the electricity also needs to be replenished regularly. Charging is an important part of battery maintenance, which directly affects its lifespan.
4. When charging the battery, the current should not be too large. It is recommended not to use fast charging, to use lhalf the nominal charging current, double the nominal charging time and put the battery in a cold place. water to cool it (the water is submerged up to 4/5 of the battery level). Since the battery generates a lot of heat during charging, if the heat is not dissipated as much as possible, the plates will bend and deform, damaging the battery.
Baidu Encyclopedia - Battery Charging