What should I do if the lithium battery is exhausted and cannot be charged?

Introduction What to do if the lithium battery is exhausted and cannot be charged. Excessive current output or excessive discharge of the lithium battery during use will cause the external circuit of the battery to be protected. When I was repairing cell phones ten ye

What should I do if the lithium battery is exhausted and cannot be charged?

Excessive current output or excessive discharge of lithium batteries during use will cause the battery's external circuit to be protected. When I was repairing cell phones ten years ago, cell phone batteries could still be removed and charged. The most common problem I encountered was that the battery was too drained and could not be recharged. There are two solutions. First, use a multimeter to measure if there is voltage on the battery contacts. If so, it means the circuit board is in protection state. Just wake it up with high voltage and it can be charged. The voltage of the mobile phone battery is 3.6 volts and it charges normally. The voltage is 5 volts. The wake-up voltage is usually adjusted to more than ten volts or more than 20 volts. After confirming the positive and negative poles of the battery, tjust touch the high voltage several times. Start with more than ten volts until the battery can. be charged normally.

Second, if there is no voltage on the battery contacts, it means the battery has been left too long and the voltage inside is exhausted. At this time, high voltage cannot be used to wake up. . Use a blade to scrape the wrapping paper at the battery contact base, remove the protective circuit board, and charge the battery directly bypassing the electrical board. This method requires professional technicians to operate. Generally, those who have no experience in electronic maintenance should not try it. After a few minutes of charging, the battery protection board can detect the voltage and it can be charged normally. The protruding part of the battery in the picture below is the circCharging protection uit. The mobile phone protection circuit is located under the contact part.

Disassemble the battery and use a 4.2V charger to charge each section separately. There is no need to fully charge it. Each level has 3 volts and can be charged together. This saves time, but the battery capacity will be significantly reduced.

The phone cannot be charged. Is it because of the battery or the charger?

Lithium batteries have a self-discharge phenomenon. If the battery voltage is stored below 3.6V for a long time and not used for a long time, the battery will overdischarge. and damage the internal structure of the battery, thus reducing its lifespan. Therefore, lithium batteries stored for a long time need to be recharged every 3 to 6 months, that is, they should be charged at a voltageion of 3.8 to 3.9 V (the optimal storage voltage of lithium batteries is approximately 3.85 V) and do not recharge them. be fully charged.

Detailed information:

< /p>

Lithium-ion batteries must remain above the minimum operating voltage at all times . or The self-discharge reaction will cause the lithium-ion active material to decompose and destroy and may not be able to be reduced.

Any form of overcharging lithium-ion batteries will result in serious damage to battery performance or even an explosion. Lithium-ion batteries should avoid overcharging the battery during the charging process.

Do not frequently discharge or deeply charge. However, every 30 charge cycles, the power sensing chip will automatically deep discharge and recharge.Deep rge to accurately assess battery condition.

Do not charge the lithium battery after it is exhausted.Is the battery affected?

1. There may be a problem with the battery power display caused by a malfunction in the mobile phone system. This type of problem is the easiest to resolve. You can directly shut down and restart. This is equivalent to refreshing the data and the overall power display will be restored.

2. The charger is defective. This type of breakdown is the main reason why cell phones cannot be charged. So how can you judge the quality of the charger? It's very simple, just try another charger. If it can be charged, then you can conclude that the charger is faulty. If you encounter this kind of problem, you have no choice but to buy another charger.

3. There is poor contactbetween the charger and the mobile phone. It is also very common that due to the negligence of cell phone users, the charger is not plugged in properly. The solution is simple, just change the socket back and forth.

4. There is a problem with the mobile phone battery. Generally speaking, it is rare for cell phone batteries to experience problems. But whenever there is a problem, it's a big problem that needs to be taken seriously. When it turns out that the charger and the mobile phone system are not faulty, you should focus on checking the battery. If you find that the battery is swollen, it means that there is a problem with the battery and you should stop using it immediately. Do not take any risk.

5. The mobile phone itself has quality problems. If you buy a copied phone, there is a high probability thatthe phone is malfunctioning. If it is a brand machine, it must be sent back to the original factory for processing.

How to solve the problem of 18650 lithium battery not charging

Once the lithium battery runs out, not charging will have an impact serious negative on the battery and will directly reduce the life of the lithium battery.

Nowadays, lithium batteries are commonly used in electronic products. When using lithium batteries, it is best not to deplete the battery before recharging, as this will reduce the battery's chemical activity. Therefore, when using electronic products on a daily basis, you should generally charge them when they still have more than 30% charge left. This is a more efficient method to extend the battery life cycle.

Second, lithium batteries being chemical batteriesues, after repeated use, a chemical reaction will occur between the battery electrolyte and the metal plate, and a passivation layer will appear on the surface of the metal plate. The passivation layer will prevent the generation and flow of current, increase the internal resistance of the battery and the power that the battery can provide will also decrease, causing the battery capacity to slowly decrease, making it less and less sustainable.

Detailed information

Lithium battery maintenance precautions:

1. Charge correctly. The number of charges is closely related to battery life. You can use some auxiliary software to manage the battery or extend battery life with multiple micro-charges.

2. Try to use the original charger and data cable, or use charging equipment matching the output power of the chargerr and the original data cable.

3. Avoid excessive battery temperature. For example, when the body of electronic products such as mobile phones and tablets overheats, the batteries of electronic products will be quickly consumed regardless of whether they are used or not.

PersonnesNet-Are batteries in electronic products becoming less durable? The lifespan of 18650 lithium battery should be extended when the battery reaches 30%.

The repair method for 18650 lithium battery not charging step is as follows:

1. The reason why the 18650 cannot be charged is that the battery electrode contacts are rusty or dirty, making the contact resistance too large and the voltage drop too large. charging, the charging device thinks it is fully charged and stops charging; in this situation only, theElectrodes must be electrocuted for cleaning.

2. After eliminating the problem with the battery itself, check if there is a problem with the charger or charging cable. If there is other charging equipment, you can try to replace it, due to faults in the system. The charger and cable may also prevent the 18650 from charging.

3. If there is a problem with the internal circuit, the battery itself, or the battery life that is preventing the battery from charging, it is recommended to replace the battery directly. If you need to disassemble the 18650 battery, you must drain all the energy from the battery, but it is strongly not recommended to perform such an operation.

Principle of repair

1. Repair Principle 1: The metal surface of lithium batteries used for a long time will be oxidized to a certain extent, resulting in poor contact between the battery of themobile phone and mobile phone, the life of the lithium battery is shortened. The rust on the surface can be wiped off with an eraser or other cleaning tools, so that the battery and the mobile phone have better contact.

2. Repair Principle 2: Low temperature can change the electrolyte inside the lithium battery and promote the chemical reaction of the newly frozen battery. The process of using a lithium battery is actually a process of charging and discharging. During this time, the negative and positive charges of the battery collide.

  • Popular Focus
  • Where is the cheapest battery wholesale?

    Where is the cheapest battery wholesale in Tangxia, Sanyuanli, Baiyun District? There is an enterprise specializing in the independent production of electric vehicles in Tangxia, Sanyuanli, Baiyun District, Baiyun Sanyuanli Avenue, Baiyun Sanyuanli Street
    08-02
  • Four 3.7V lithium batteries in series and parallel produce 7.4V/4.4A. How to reduce it to 4.8V/4.4A?

    Four 3.7V lithium batteries in series and parallel produce 7.4V/4.4A. I personally think it is impossible to reduce it to 4.8V/4.4A. Because the discharge platform of lithium batteries is generally set
    08-10
  • What are the materials of the negative electrodes of lithium batteries?

    What are the materials of the negative electrodes of lithium batteries? The main commercial applications of lithium batteries include graphite, which is a sheet of copper used to guide current and which does not react. another safe
    08-02
  • The difference between 18500 and 26500 batteries

    What is the difference between 18500 and 26500 batteries? The answer above is 18650. The person asking the question should ask what is the difference between 18505 and 26500 batteries. In the case of Fuant ER1
    08-02
  • What does 3.7V 80mAh written on a lithium battery mean?

    What does 3.7V 80mAh written on a lithium battery mean? 3.7 V, 80 mA = 0.08 A, H means 1 hour, or 3600 seconds. Taken together, it is
    08-02
  • How long does a lithium battery (cell phone battery) last?

    How long does a lithium battery (cell phone battery) last? The lifespan of mobile phone batteries, under normal conditions of use and without serious impact, the lifespan set by the manufacturer must be 5 years.
    08-02
  • Will lithium batteries explode when charging?

    Will lithium batteries explode when charged? Will lithium batteries explode when charged? Lithium battery explosions usually occur during the charging process, because the negative electrode material of lithium batteries is graphite or other carbon materi
    08-02
  • Parameters of lgdas31865 lithium battery

    Parameters of lgdas31865 lithium battery The parameters of lgdas31865 lithium battery are as follows: LGDAS31865 is a model 18650 lithium battery with a capacity of
    08-02
  • What are the main components of lithium battery electrolyte?

    What are the main components of lithium battery electrolyte? The composition of lithium battery electrolyte is shown below. 1. Ethylene carbonate: molecular formula C3H4O3. Colorless transparent liquid (>35℃), room temperature
    08-02
  • Who are the lithium battery manufacturers in Shandong?

    What are the lithium battery manufacturers in Shandong? Shandong Shengyang Power Supply Co., Ltd. and Shandong Weineng Environmental Protection Power Technology Co., Ltd. 1. Shandong Shengyang Power Supply Co., Ltd. is located in Shengyang, Qufu City.
    08-02
  • Types of drone batteries available in 2024

    Part 1. Types of drone batteries available in 2024In 2024, drone batteries have advanced significantly, offering a range of options to cater to various needs in
    07-30
  • How long does it take to charge 26650 battery?

    How long does it take to charge a 26650 battery? The charging time for a 26650 battery is generally between 3 and 6 hours, but the precise time depends on the power of the charger and the capacity of the battery. in general
    08-02
  • For what?Sure, here's an article based on the phrase "For what?

    The simple yet profound question, "For what?" often serves as a gateway to deeper reflections on purpose and intention. It is a query that invites us to delve into the reasons behind actions, decisions, and circumstances that shape our lives and the wor
    08-02
  • Choosing the Right Cart Battery

    This comprehensive guide will walk you through everything you need about cart batteries, from understanding different types to making an informed purchase decision.
    08-02
  • 30mAh~500mAh 3.7 V Li-ion Battery

    Welcome to Ufine's collection of 3.7V lithium-ion batteries ranging from 30mAh to 500mAh. Explore a diverse range of compact and lightweight batteries suitable for various electronic devices,
    08-02
  • Here are 10 essential facts about drone batteries for 2024.

    10 Key Facts About Drone Battery for 2024 In 2024, drone batteries have advanced significantly, offering a range of options to cater to various needs in the consumer, commercial, and industrial sectors. Below are the primary types of drone batteries avai
    08-02
  • Could you please explain the difference among IMR, ICR, INR, and IFR 18650 batteries?

    What is the Difference Between IMR, ICR, INR, and IFR 18650 Battery?In 18650 batteries, discerning the differences among IMR, ICR, INR, and IFR types is fundamental for tailored and efficient battery usage. These distinct
    08-02
  • Safety considerations for cart batteries

    Selecting the ideal cart battery is crucial for ensuring optimal performance and longevity of your electric vehicle or vaping device. This comprehensive guide w
    08-01